Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Angle of saw (dumbness confession)

Posts

Angle of saw (dumbness confession)

#1

Angle of saw (dumbness confession)

Bill Houghton, sunny Sebastopol, CA

>So, I'm shaping window sills for trimming out the windows in the kitchen/laundry room, which requires cutting the horns for the sills (the part that runs beyond the window opening along the wall with casing sitting on top of it, for those unfamiliar with what are at least West Coast terms). I'm doing it by hand for more precision, using my favorite handsaw*, which is filed cross-cut**. The rip cuts are going rather slowly until I remember: 60 degrees to the board, not 45. Once I get the saw closer to vertical, it SAILS through the wood. Amazing how much difference a small change in toolholding can make.

Bill, enjoying making kitchen progress

*Disston medallion, skew-back, very thin sawplate. I've never sanded it down seeking the etch, but the handle was made in a wheat-carving-free zone, even if the electrical tape covering the wood putty where part of the grip broke does detract a bit from the gracefulness. It handles well, and the thinness means it cuts quickly with less effort.

**Yes, yes, I should have a rip saw. I do, but it's a post-WWII Disston, suitable only for rough carpentry. Some time, I'll send one of my better saws to someone for refiling rip.

Re: Angle of saw (dumbness confession)

#2

Whatever works

David Miller from Iowa

>I have maybe 50 handsaws, but they were in storage while I built my new house. I bought a cheapo Stanley "shark" saw to leave around the job site and it was quite serviceable - even for "finish" work (noting that everything I used it on was later painted).

Having the right tool is great, looking for the primo tool longer than it takes to do the job is pointless when another functional tool is in hand.

David