Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Hardwood floor expansion

Posts

Hardwood floor expansion

#1

Hardwood floor expansion

David Miller from Iowa

>Built a new house a year ago and am just now getting to the shop. Have some extra ash flooring (Bellawood) that I am using for counter tops, and I just pulled it down from the ice cold attic. Instructions say I should let the wood equilibrate to its new environment for two weeks due to expansion/contraction issues, but I am ready to finish the project this weekend.

Should I follow the directions or just go for it after 48 hours? I could see this being a big deal for a 15 foot wide room, but would it matter over 36 inches?

David

Re: Hardwood floor expansion

#2

Re: Hardwood floor expansion

Sgian Dubh

>American Ash has tangential shrinkage value of about ~7.8% and a radial shrinkage factor of ~4.5% from 30%MC to 0%MC.

If your boards are currently 15%MC and they stand a chance of drying to 7%MC when laid out as a floor in your house then you can expect a 36" wide cross sectional assembly to shrink by anything up to 3/4" at some point within the next twelve months.

This is a worst case scenario assuming every board is perfectly tangentially cut, ie, there isn't any rift or quarter sawn parts in any of the boards which means they would shrink less across their width. I'm also guessing at the current MC being 15%; it could be less or more. And it's not absolutely certain a floor in a house will dry to 7%MC, but it's possible.

So I've provided you with what could be pretty close to the maximum shrinkage you might expect. It would be prudent to let the boards acclimatise to current indoor conditions for a couple of weeks if you don't know what the current MC of the wood is.

Why not stick a moisture meter into the stuff and get a reading, then decide what to do? If the wood currently reads about 9%MC or 10%MC go ahead and do the floor. If it reads 15- 16%MC I'd let the stuff acclimatise for a couple of weeks. Slainte.

Re: Hardwood floor expansion

#3

Jesper, Denmark

Re: Hardwood floor expansion

Jesper, Denmark

>You could fix the countertops at the back and allow some expansion or contraction at the front by using slotted screw holes or just by letting the screw block in the carcas sit about � inch below the top of the carcas to allow some movement.

Re: Hardwood floor expansion

#4

Re: Hardwood floor expansion

Sgian Dubh

>Somehow Jesper I lost the fact that this ash is intended for a countertop. Nevertheless the information on the range of possible movement is valid.

However, your suggestion of fixing a wooden countertop at the back could lead to problems at corners. Inside right angle corners for example need the end grain of one run butting up at right angles to the edge of the perpendicular counter top running the other way. This prevents serious gaps opening up, so it also means fixing at the front edge leaving the back edge to move over the seasons. An upstand at the back of some sort is required to hide the gap at the back. Slainte.