Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

A handle for my burnisher

Posts

A handle for my burnisher

#1

A handle for my burnisher

Dominic Greco in Richboro PA

>Hi Everyone,

I just whipped this up yesterday while puttering around in the shop. I had the Hock burnishing rod for a while but never got around to putting a handle on it. So after I finished tuning up my #12 and #80 scrapers yesterday, I scrounged around and found a small scrap of Bocote and a 1/2" Brass Compression Nut.

In case you are wondering, the flats on the hex nut could have been "turned" smooth to present a nice clean surface. But then I wouldn't be able to unscrew the ferrule and remove the burnisher if I ever wanted to make a new handle for it.


After turning a tenon to size fit the inner diameter of the nut, I removed it from the lathe and threaded it onto the handle. I then un-thread it, and treat the newly "cut" threads with CA glue. This is a trick I use all the time with my turning tools. I tend to make new handles for a lot of my tools since the factory supplied ones are always too light.

The handle has several coats of Danish Oil. This was allowed to dry overnight. Afterwards it was buffed with a Beall Buffing system and given a coat of wax

Thanks for viewing.

See ya around,

My ugly mug


Dominic

Re: A handle for my burnisher

#2

That's pretty!

Scott Burr in cold Ben Lomond, CA

>You did a very nice job on it.

Re: A handle for my burnisher

#3

Re: That's pretty!

Todd O. Cronkhite Maine Native, Presently Away

>It's amazing what some folks can whip up while just puttering around.

Nice job Dom, sure turns a nondescript tool into something highly desirable.

T.O.

Re: A handle for my burnisher

#4

Thanks guys

Dominic Greco in Richboro PA

>Thanks for the compliments guys. To be honest with you, this little project re-kindled my love for turning. Since my hand tool addiction got "turned up a notch" I haven't been turning as much as I used to. It's nice to see I still can make something like this.

Dominic