Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Lighthouse Service tool box *LINK*

Posts

Lighthouse Service tool box *LINK*

#1

Lighthouse Service tool box *LINK*

Ken Martin

>I just found a site for the Michigan Lighthouse Conservancy that has photos of a tool box issued to a Lighthouse keeper for maintenence. There is also a list of tools that are supposed to be in the box. I found it interesting.

Ken


USLHE Tool Chest

Re: Lighthouse Service tool box *LINK*

#2

Re: Lighthouse Service tool box

Rick Jackson, Tn

>Ken very interesting, thanks for sharing this

information & Merry Christmas.

Re: Lighthouse Service tool box *LINK*

#3

Whee! Hours of speculation there

Bill Houghton, Sebastopol, CA

>Interesting that the auger bit selection is incomplete. I guess the lighthouse maintenance folks figured out just what sizes would be needed and left out the unnecessary ones.

Anyone know what sizes #4, 5, 7, and 8 gimlet bits would be?

Moving away from our trade: no visible metal drilling bits (although such bits were available for braces - I've started, um, gathering them when I find them at garage sales). Only one Stillson wrench - I always thought these had to be used in pairs, one to hold the pipe that you were removing or tightening, one to hold the fitting from which you were removing/into which you were installing the pipe.

Re: Lighthouse Service tool box *LINK*

#4

Re: Whee! Hours of speculation there

Ken Martin

>> Anyone know what sizes #4, 5, 7, and 8 gimlet bits would be?

Gimlets are measured in 1/32nds so a 4 would be 4/32nds or 1/8".

Ken

Re: Lighthouse Service tool box *LINK*

#5

Gimlets

Bill Houghton, Sebastopol, CA

>So those would cover sizes below the sizes covered by the auger bits, except for a little overlap at 1/4". Plus, the recent thread on bits for drilling flutes imply that gimlet bits might be better for drilling into end grain - ?