Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

legs not level

Posts

legs not level

#1

legs not level

chichi

>I made a small stool and the legs are not level. In the past, I have used a spirit level and established the plane of the shortest leg by making a mark on each leg level with the bottom of the shortest leg. I then removed the extra length from the 3 longer legs. For whatever reason, this never worked that well for me.

Is there a simple dummy proof method to levelling legs?

Thanks,

Bob

Re: legs not level

#2

Re: legs not level

markfromsacramento

>Put the stool on your table saw with the longest hanging off the edge. Mark the amount that it hangs over the edge and plane this amount off--voila, it's level!

Re: legs not level

#3

Re: legs not level

Pam Niedermayer - Austin, TX

>You need a simple compass with pencil on one leg. Set the stool on a level surface and set the compass to measure the distance from surface to shortest leg. Then scribe that measure to the other legs with the compass.

Pam

Re: legs not level

#4

another method

Mike Schwing from Md.

>In addition to those posted - there are always multiple ways to skin a cat.

Attach a piece of sandpaper to a flat surface, like an assembly table or a tablesaw top. Rub the tip of the longest leg back and forth on the paper, checking it regularly, till it is no longer the longest leg. Takes a bit longer with multiple legs, but still works.

Re: legs not level

#5

Re: legs not level

Don Pierson

>Next time make a three legged stool...then you don't have to worry about level.

Re: legs not level

#6

Re: legs not level

Adam Cherubini

>What I do is invert the object then mark each leg with a story stick. When this doesn't work, I put the object on its legs, shim one leg until the top is where you want it. Then using a small stick or a pencil- anything with uniform thickness, mark that thickness on each leg, up from the floor.

That's how I do it.


img

Re: legs not level

#7

A friend of mine...

Stephen Shepherd in the State of Deseret

>Made a kitchen table and asked me how to make all of the legs level.

I suggested that he cuts off the longest leg until it is level.

If you are good you will end up with a kitchen table,

if your skills are somewhat less you will end up with a coffee table,

if your skills are not that good you will end up with a pallet.

Good Luck ;-}

Stephen

Re: legs not level

#8

Re: A friend of mine...

Todd O. Cronkhite Maine Native, Presently Away

>and if you're slkills are like mine you'll end up with a cutting board! }:~[

T.O.