Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

finishing problem

Posts

finishing problem

#1

finishing problem

Les Winter

>I needed to refinsh two small cherry tables with maple breadboard ends. I tried planing and scraping, but the cross grain at the ends was giving me trouble. So I broke out the sander and had done with it. When it was all over I noticed a few remaining small patches (dime size) where the previous finish still remained. These I scraped off.

After applying Formby's low-luster tung oil finish, these same patches show up as glossy areas under the finish. A light rub with 4/0 steel wool all across the top, and they disappear, but the finish looks too flat. Another coat of finish restores the nice appearance, but the patches come back.

I'm stumped.

Re: finishing problem

#2

Re: finishing problem

MikeW

>Hi Les,

Did you by chance use F-clamps at those areas directly on the wood?

If so, the plastic pads (especially on Jorgy's) can/will impart an oily residue into the surface.

Take care, Mike

Re: finishing problem

#3

Re: finishing problem

Les Winter

>thanks Mike. No f clamps there, but the plastic thing is interesting.

Re: finishing problem

#4

Just as soon . . .

steve mackay

>as I get them home those plastic pads go into the circular file !

Re: finishing problem

#5

Re: finishing problem

Marv

>Les,

I would suggest that the grain in those small areas was originally like a sponge and sucked the old finish deep into the wood. I have experienced the same thing when reconditioning old handsaw handles. Sometimes I can fix it by just sanding a little deeper and not steelwooling it until after I apply my choice of finish. Sometimes it works and sometimes not depending on how deep the old finish had penetrated.

Marv