Stanley Chisel Type
Robert L.
>I just obtained several Stanley socket chisels without handles from my father-in-law and was hoping someone could help me figure out the model. I can't seem to find them anywhere on the net or in my books...I have several everlasting and several 750's and they don't have any similar markings. He seems to think they would be from the 1940's but he is just guessing based on when he thinks his friend would have most likely bought them.
Each of them say STANLEY in capital letters at the top of the socket with MADE IN USA in caps just below the word STANLEY. They seem to be bench chisels since they are too long to be butts and too short to be paring. But they could have been paring at some point and just used a bunch. They have all been ground/sharpened at least once.
The milling marks look a bit more course as compared to my other Stanley chisels...not sure if this helps.
Sizes ranges from 1/4" to 2".