Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

REPAIRING A MORTICE MARKING GAUGE

Posts

REPAIRING A MORTICE MARKING GAUGE

#1

REPAIRING A MORTICE MARKING GAUGE

BEN

>I picked up a mortice marking gauge recently and want to replace the metal scribe pins. This gauge has one scribe that goes through the wooden beam and marks on either side of the beam and one scribe set into a moving brass strip that is set into a sliding dovetail. All the scribe points are trashed and need replacing.

Does anyone have an idea how these points are set into the tool?

Is the one set in the brass peened in or is the brass squished onto it? How is it held into place?

How about the through scribe? I assume it is a single piece of metal that goes through but how is it retained in the tool?

Thanks

Re: REPAIRING A MORTICE MARKING GAUGE

#2

Re: REPAIRING A MORTICE MARKING GAUGE

Pam Niedermayer - Austin, TX

>In my gauges with brass mounting, there's a small plate secured with a tiny screw. Unscrew it, put a small tack or whatever in through the back of this plate, etc.

Don't know on the through scribe. How about a photo?

Pam

Re: REPAIRING A MORTICE MARKING GAUGE

#3

Re: REPAIRING A MORTICE MARKING GAUGE

Stephen Shepherd in the State of Deseret

>Older gauges are usually set either with heat, expanding the brass or peening. If you can disassemble the gauge and get to the back side you can see what you are up against. Sometimes you can just use a punch to push out the iron plug enough to sharpen it on the surface, thereby using the original material.

If you can push them out and they are square you can get square cut steel shoe nails, still available from suppliers and they work well for the new scribe. Sewing machine needles work as well, any high carbon steel will work.

Try and conserve as much of the original as possible and replace with appropriate materials (not stainless or some other fancy new metals).

Stephen