Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Stanley #40 question

Posts

Stanley #40 question

#1

Stanley #40 question

Robert Henderson

>I just bought a Stanley #40 scub plane on ebay.

It came with the blade bevel up, but that put the logo on the blade on the underside, so I wondered...

Is this plane used bevel up or bevel down?

Re: Stanley #40 question

#2

Down

Denis Ch�nard, Orl�ans, Ont.

>

Re: Stanley #40 question

#3

General principles

Bill Houghton, Sebastopol, CA

>If the iron (blade) is at 45 degrees or above, it's bevel down; at 20 degrees or lower, bevel up.