Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Source of Conical Ferrels?

Posts

Source of Conical Ferrels?

#1

Source of Conical Ferrels?

Paul Erickson

>Anyone know a source for small conical ferrels? Attached is a picture of a handle I picked up some time ago, and I want to make some more of them. For size reference, that is a 2mm allen key sticking out of the end.

Thanks in advance.

cheers, Paul


img

Re: Source of Conical Ferrels?

#3

Re: Source of Conical Ferrels?

Michael Recchione

>You could turn these from brass rod fairly easily on a wood lathe, using the same tools that you use for turning wood - I've turned brass on my lathe many times, to make things like ferules and other small parts. You can, of course, use a treadle or springpole lathe :-).

Re: Source of Conical Ferrels?

#4

Re: Source of Conical Ferrels?

ThomD

>If you can't find what you want, you could spin it out of flat brass stock on a wood working lathe.

Re: Source of Conical Ferrels?

#5

Re: Source of Conical Ferrels?

Paul Erickson

>Thanks for all the replies.

cheers, Paul

Re: Source of Conical Ferrels?

#6

Re: Small brass compression nuts?

Peter Hyde

>Here is how I used them. The top Pyramid tool has the flats left on the nut as a reference for grinding the 3 faces of the point. The middle small skew has the nut faces turned off after installing.

I size the end of the handle so that the nut cuts a thread as it is screwed on and a drop of CA glue makes sure it doesn't loosen.

The bottom scraper has a salvaged ferrule fromthe old chisel that was used to make the tool.

Oh by the way these are for lathe work, another far steeper slippery slope :-(((


img

Re: Source of Conical Ferrels?

#7

Re: Source of Conical Ferrels?

dave jeske

>If you do not feel comfortable using turning tools for brass on a lathe you can also use files and sandpaper on blocks of wood (finish work). Make sure the files have handles on them :)

Turning small brass parts on a lathe is not too hard though.

dave