Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Vice, vice

Posts

Vice, vice

#1

Vice, vice

Stephen Shepherd in the State of Deseret

>My wooden Patternmaker's Vice raises work up off the bench top (cluttered) and this little casted iron vice brings it up even higher.

It has fine jaws and a brass spring to open the jaws when the pressure is released. Early casting wide sprue.

Stephen


img

Re: Vice, vice

#2

Re: Vice, vice

Paul Kierstead

>Very interesting. Is this from an old pattern/piece or an invention of your own (the wood version of course)? Does it swing/swivel as well?

Re: Vice, vice

#3

Re: Vice, vice

Marv

>Looks like it's mainly for relatively thin stuff....bet my bench is messier....Is that a pile of beef jerky in the background?

Re: Vice, vice

#4

Re: Vice, vice

Stephen Shepherd in the State of Deseret

>It is a traditional design but it is my second iteration with some variation. The original had side pieces to reinforce the joint between the fixed jaw (the one in the rear) and the piece that is affixed to the bench. These pieces may have been added later. I omitted them on this version. It swivels and can be mounted on the face of the bench. Mounts through a dog or holdfast hole.

Stephen


img

Re: Vice, vice

#5

Re: Vice, vice

Stephen Shepherd in the State of Deseret

>Marv,

The jerky is in the tin box, to keep the mice from eating it, the item you think is jerky is actually a tanned frog skin. You never know when you might need one.

Stephen

Re: Vice, vice

#6

Correction

Stephen Shepherd in the State of Deseret

>The fixed jaw is the one in the front. The added side pieces prevented the work from going below the surface of the bench. By not having those pieces the work can extend down in front of the bench.

Sorry for the mistake.

Stephen

Re: Vice, vice

#7

Harnessmaker

David Miller from Iowa

>Neat idea. Just though I would metion that I believe the iron vise is for harnessmaking/saddlemaking. My dad owned a hardware store for 40 years and he had, up in the attic storage, an actual display full of harnessmaking tools which included a couple vises like this. Clamp two pieces of leather together then sew them up.

Re: Vice, vice

#8

Lust, lust !

s.mackay@worldnet.att.net

>

Re: Vice, vice

#9

Re: Correction

Marv

>Stephen,

Here's a thought...the base part could be much wider with the swivel point in the back and a curved slot for a bolt the sticks up with a large flat washer and a tightening lever of some kind. The the front part of the vise could extend well out in front of the bench. The wider base would give the over-vise more stability and more moveability both to the right and to the left. But you'd have to have a less cluttered bench...*smirk*

Marv

Re: Vice, vice

#10

nice vice

dave brown

>Nice vice! Where did you source the wooden screws?

Re: Vice, vice

#11

Re: nice vice

Stephen Shepherd in the State of Deseret

>I make them, I have dies and taps for 1/2" to 1 1/2" and I am having the blacksmith make up a 2 1/2" tap to make a large die.

Stephen

Re: Vice, vice

#12

Re: nice vice

dave brown

>Thanks for the info Stephen! I emailed you with a few questions -- hope that's ok.

regards,

Dave