Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Stanley 9 1/2 question

Posts

Stanley 9 1/2 question

#1

Stanley 9 1/2 question

Bill Tindal, E.TN

>This story could be titled the perils of buying something you don't know anything about.

I was at our flea mkt Sunday looking for some of the 27 ingredients for the Mole I was attempting to recreate when I spied a 9 1/2 in what seemed to be nice condition. I need a good high angle block plane so I bought it. Sharpened up the iron (boy was it soft compared to the plane irons I typically sharpen), installed it and attempted adjustment. It didn't adjust depth. There is a wheel with cogs that I suppose engages in slots in the iron? It seemed the slots in the iron didn't line up with the cogs properly. The identification numbers on the iron are Stanley-No. 118P(13-118A)- U.S.A.

The bottom line question is what can I do to make the plane usable? Do I need a different iron (where to obtain) or are the cogs messed up, or whatever?

A less worrisome problem is the lateral adjustment lever rubs ont he knurled depth adjustment wheel. Does it need bending to get it out of the way?

Re: Stanley 9 1/2 question

#2

Re: Stanley 9 1/2 question *LINK*

Bill Houghton, Sebastopol, CA

>Simple one first: yes, you should bend the lateral adjuster lever so it doesn't rub on the wheel, although in the best of circumstances they're kind of close together. The Wards Master Stanley clone I bought some time back has that same problem - I suspect it's not a rare problem, since the lateral adjuster lever seems to be soft steel, not tempered at all, and it's hanging out the back there, ready to be bumped.

About the iron: if you scroll down in the link below from Patrick Leach's Blood and Gore, you'll find a picture of the adjusting mechanism on the classic 9-1/2 (which is what it sounds like yours is): upright threaded post at the back with a knurled wheel, which engages a slot in a lever. The lever pivots in a part of the casting on which the iron rests. At the pivot point, at 90 degrees to the slotted part, are some little teeth, which should engage slots in the iron.

More recent Stanley block planes use a different iron, and also use a very different lateral adjuster mechanism. If someone put a later iron on an older plane, they might well not mesh. The slots on an older iron do not go all the way through, but are arc-shaped, like, to use a comparison from the electron-burning side, the slots made by a biscuit joiner. I believe, though I'm no expert, that the slots on the later irons are milled all the way through (or possibly punched through).

I have found that, at certain sharpening points, an older iron will not stick through the sole of the plane until the wheel is all the way at the top of its travel; the cure is to grind the iron a bit more and set it down on the next slot.


Professor Leach on the 9-1/2

Re: Stanley 9 1/2 question

#3

wrong iron

Bill Tindal, E.TN

>From your description I am quite sure I have a new iron in an old plane. Any source for an iron that will fit the old plane?

I need to stop to buying old tools. I get screwed every time, one way or another.

Re: Stanley 9 1/2 question

#4

Right iron

Bill Houghton, Sebastopol, CA

>Most of the online sources list replacement irons by some of the specialty makers (Hock and so on); just make sure you get an "old-style" iron.

Or e-mail me your address, and I'll mail you a Stanley iron.