Re: Yet Another Saw Bench
Paul Kierstead
>Ah, well, pictures you know....
First I made a half template using some 1/4" plywood using a bandsaw and spokeshave (yes, I used a spoke shave on plywood 'end grain', works amazingly well). I made it as fair as I could. The drawing was done with a tension bow thingie. I transferred the template to the top and bandsawed it out, no clean up. A bandsaw can leave a reasonable surface if you are going slow. In this case, on one side I went slow and tried to be 'instinctive' ... just go with it. I missed my line by a fair bit (say 1/8" or so). That is the side you can see. The finish is not polished, but more then good enough to be interesting at least. The other one I got a little pig headed about sticking to the line and it resulted in a less-then perfect finish since I was manipulating a little too much. I might take a swipe or two with a spoke shave to make it look better, but oddly enough once I forget to look for it it still doesn't look too bad. The two sides don't match (due to missing the line on one and not the other), and I was all prepared to fix that but inadvertently wiped out the line finish planing the top. Then I realized you couldn't tell anyway ... the eye expects them to be the same and seems to let it be. I am a perfectionist by nature and hand tools are slowly teaching me to focus the perfectionism to where it matters.