Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Stanley 239

Posts

Stanley 239

#1

Stanley 239

Raymond Overman in SC

>I was over at a friends house this afternoon helping him turn some tenons on some cedar limbs for a log bench when he started digging through a "junk" box of tools looking for other pieces to the lathe. In the bottom was a Stanley block plane that was in pretty good shape, a no. 5 that the front half was gone, and a no. 239 that had some surface rust but was in overall good shape.

I mostly cruise the turning forum but I immediately thought about the crowd here when I saw it. I'll have to go back and get a picture if anyone here is interested. What would be a fair price to offer him for it?

Re: Stanley 239

#2

Re: Stanley 239

Jim Reed @ Tallahassee

>There is one on the bay right now and it is up to $81. The #239 has limited appeal to users, but collectors seem to like them. Lots of little pieces. Make sure this one is complete and has all of the blades. Otherwise, it is garage sale stuff. I suspect it is a partial in unknown condition--$5.00 would be my offer.

Re: Stanley 239

#3

Re: Stanley 239

Todd Hughes

>First the 239 only came with one blade, [the sort of simular looking 238 had 7 cutters]but there were 5 different planes depending on which blade they took going from the 239 1/8 up to the 239 1/4. Early on a 1/2 inch size was made but is not marked 1/2 this model will bring extra as will the 1/4 inch one Also early 239s did not have a fence.If it was supposed to have a fence there will be empty holes in the side.

These planes "book" for between $150-$300 with the 1/4 and 1/2 inch ones worth about $50-$100 more. I have sold a few of them and they sell very well if in nice condition going for about the middle range of book price.I think most were bought by users since apparently they are very nice planes to use to cut dados.I have a friend that uses one for fitting drawer bottoms and likes it.

As to what to offer the guy I can't give you any advice other then to try to get him to tell you what he wants since after all it is his stuff to sell. Like it is the buyers job to decide what he will pay it is the sellers job to decide what he wants.Personaly I would pay $40-$50 for a very nice plane, maybe even a bit more, but then I would be buying to resell.......Todd