Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

attaching molding question

Posts

attaching molding question

#1

attaching molding question

Jerome Bias

>Tomorrow I will be making a strip of molding to go on my chest. I am a little nervous about that okay a lot nervous.

Anyway I noticed that where the molding is to be attached it will cross over from the rail to the legs. I didn't get everything flat all of the way across. When I put a test strip of wood up against it today there is was a small gap there <1/16".

How do y'all use tend to deal with situations like this? I am a little tempted to cover my eyes and say "see nothing". The chest will be painted with milk paint and slightly distressed.

Thanks,

Jerome

Mebane, NC

Re: attaching molding question

#2

Re: attaching molding question

Bill Tindal, E.TN

>It is not clear to me where the problem is located but in any case I would be flattening what ever needed it to not have molding gaps. that is a nice chest and it deserves careful trimming.

Re: attaching molding question

#3

Re: attaching molding question

slashdev

>I think the rail is maybe set back from the face of the leg by 1/16". If that's the case, make your moulding a little deeper so you can cut a relief in the back for the legs.

Re: attaching molding question

#4

I'll give it a try

Jerome Bias

>

Re: attaching molding question

#5

Jim in Burlington Ont.

It's going to be painted

Jim in Burlington On

>So if your going to pain why not put a filler strip in?