Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Wolverine upgrade

Posts

Wolverine upgrade

#1

Wolverine upgrade

Jim Reed @ Tallahassee

>I use my Wolvering jig alot and love it. There is a problem using it for small items. I came up with this idea one day when I was making a #46 blade and the grinder *ate* it. When that happens, it makes your shop day pretty lively. Once you stop trembling, you can search for the little bent shard of metal that you heard pinging around the shop. This picture is the new floor plate for the Wolverine. It is 1/16" thick.


img

Re: Wolverine upgrade

#2

In place

Jim Reed @ Tallahassee

>Here is the new plate in place. I just clamp it to the Wolverine flat jig. I put a blade blank in place so you can see how the plate provides that really important side support.


img

Re: Wolverine upgrade

#3

Re: In place

Todd O. Cronkhite Maine Native, Presently Away

>can see how the plate provides that really important side support.

No Jim, sorry I can't. Guess I'm being as daft as a brush, but I dunno what you mean by "side support".

I see that the plate surrounds the wheel on 3 surfaces, but I dunno how this makes it wasier--or safer--when making #46 blades.

'Splain me more?

At any rate, good show on taking the time to make a safety device. Running off to the hospital and getting body part put back on is time consuming unto itself, not to mention the loss of shop time, plus, more than likely during recovery you'd probably be cooped up in the house with the Mrs., and that I do believe would fall into the catagory of self inflicted torture. :~O

T.O.

Re: Wolverine upgrade

#4

Some detail

Jim Reed @ Tallahassee

>Here is what happens--the Wolverine stops in front of the wheel like most grinder tool rests. That works great if you have a long piece of metal that is supported by the rest. Think of what happens when you sharpen a chisel. You hold the handle and stick the blade tip into the grinder. There is lots of support for the workpiece. Now imagine that you have a tiny 3" piece of steel and you need to grind a relief on the side. If there is 1/4" of clearance between the rest and the wheel, and if your tiny piece of 3" steel is only 1/2" wide, then very little is supported by the rest. The steel will wobble and get sucked into the wheel. Having side support means that you can safely grind the edge of the steel while it is supported at each end. Hope this helps.

Re: Wolverine upgrade

#5

Re: Some detail

Phil Joines Krum, Tx

>I sharpen a lot of small tool bits for my turning tools. I cut the Wolverene plate to fit around the wheel.