Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Anyone know how to fix a Yankee 2101 chuck

Posts

Anyone know how to fix a Yankee 2101 chuck

#1

Anyone know how to fix a Yankee 2101 chuck

Stephen Kirk in Quakertown, PA

>My Yankee brace was operating badly when opening and closing the chuck, so I pulled the chuck off to clean it out. Of course then the jaws popped out and the spring opened up. In attempting to put the jaws back in, I bent the spring. Does anyone know of a trick to straighten the spring out, and then get those jaws back in. I have no idea how to cross the sides of the spring and then put the jaws back into place.

Hopefully I didn't just destroy my old brace in an attempt to clean it.

Re: Anyone know how to fix a Yankee 2101 chuck

#2

Re: Anyone know how to fix a Yankee 2101 chuck *LINK*

wayne anderson

>Try this link:

-wayne


http://www.georgesbasement.com/fs2101a.htm

Re: Anyone know how to fix a Yankee 2101 chuck

#3

Re: Anyone know how to fix a Yankee 2101 chuck

Stephen Kirk in Quakertown, PA

>Thanks, I had checked his page out earlier. Unfortunately, he talks about cleaning the ratcheting mechanism, and doesn't cover the chuck.

Re: Anyone know how to fix a Yankee 2101 chuck

#4

Re: Anyone know how to fix a Yankee 2101 chuck

Todd O. Cronkhite Maine Native, Presently Away

>From the one experiance I've had with a disassembled chuck I think it hopeless. however, if you so wish to spend the time, I think that with some creatity in making some type of jig, it could be done. I have the bits in pieces of mine in a container somewhere, waiting for the day when I decide to take another stab at it.

Mine was not a Yankee 2100 series however, just a common hand drill three jawed chuck. The real bugger is getting the springs that go between the jaws back into place, hence, the jig idea.

Good Luck getting your back together, and let us know either way how it goes eh?

Todd O.

Re: Anyone know how to fix a Yankee 2101 chuck

#5

Bummer

Stephen Kirk in Quakertown PA

>I think I'll give it a go, but I may as well keep my eyes out for some more working braces. I do tend to see them all over the place for little to nothing. I guess this kind of replacement is one of those things that no one knows how to do anymore, but couldn't have been an uncommon repair. I figure that there was a specific tool which did it.

Dare I even consider the new one that Lee Valley sells?

Re: Anyone know how to fix a Yankee 2101 chuck

#6

Well, the spring broke

Stephen Kirk in Quakertown, PA

>As I tried to fit the jaws back in. But, that doesn't stop the brace from working. You can hold the jaws open, fit a bit in and tighten it down. Still drills like a champ. You just have to be careful not to turn the brace right side up until the jaws are tightened or they'll fall out.

Could be worse and not work at all I guess. I'm going to keep hunting for something to use as a replacement spring. I tried some of those really strong binder clips, but the wire is too thick.

Re: Anyone know how to fix a Yankee 2101 chuck

#7

Re: Well, the spring broke

Joe Rogers, Northern Virginia

>Try ball point pen springs...I use them for tons of stuff. Sort of a renewable resource.JR