Keen Kutter Project
Jim Reed @ Tallahassee
>As I continue to flit around in the shop like a just born butterfly, I have yet to run out of distractions. Today's project was a side cover for a Keen Kutter #140.
Keen Kutter Project
Posts
Re: Keen Kutter Project
#2Another view
Jim Reed @ Tallahassee
>Here is another view
Re: Keen Kutter Project
#3From the bottom
Jim Reed @ Tallahassee
>Here is the bottom view
Re: Keen Kutter Project
#4Cool!
Scott Burr in Ben Lomond, CA
>How did you attach the pins to the side plate?
Nice job!
Re: Keen Kutter Project
#5Re: Cool!
Todd O. Cronkhite Maine Native, Presently Away
>Man Jim, you're on quite a re-hab streak here lately. YOU GO BOY!!
Next thing we know there'll be a Tallahassee Toolworks!
Todd O.
Re: Keen Kutter Project
#6Hey Jim - Lookin' GOOD. :>)
V Parisian
>
Re: Keen Kutter Project
#7How
JimReed@tallahassee
>First have to drill a hole & then a larger hole slightly smaller than the rod. Chamfer the outside, hammer the rod thru from the back, put it in a vise and peen the top into the chamfer. Then grind off the outside of the mushroom.
Re: Keen Kutter Project
#8Thanks for sharing!
Scott Burr in Ben Lomond, CA
>
Re: Keen Kutter Project
#9Nice!
Joe Rogers, Northern Virginia
>