Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

"Saw speak" . . .

Posts

"Saw speak" . . .

#1

"Saw speak" . . .

Steve Mackay


>Since I've restored a couple of elder Disstons and am sending them off to sharpen, I've been paying attention to the "saw speak" ( kerf, fleam,etc.) and I'm swimming in it. For the simple-minded GI . . . if I have a rip saw, can it be sharpened into a cross-cut ? And vis-versa. I know there are volumes on this subject of saws, I just don't want to ask for something that turns into a VERY expensive project.

Re: "Saw speak" . . .

#2

Re: "Saw speak" . . .

mikew


>Hi Steve--the short answer is yes, and it shouldn't cost noticably more if not the same. I don't know if Steve Cooke or whoever you are having sharpen them charges extra for retoothing [changing the PPI, correcting poor teeth ad hoc, etc.] but that should be the only "extra" cost compared to a "plain" sharpening.

Take care, Mike

Re: "Saw speak" . . .

#3

Re: "Saw speak" . . .

Steve Mackay


>Thanks for the "short answer" ! Just what I was looking for. Like Tom above, I'd really like to USE them !

Re: "Saw speak" . . .

#4

Re: "Saw speak" . . .

dennis mcdonaugh


>He charges extra to joint a badly sharpened saw, it should be the same to retooth to a new configuration.

Re: "Saw speak" . . .

#5

Suggestion for something not to do...

Dave Thompson


>The first D8 saw I bought on e-bay, had a beautiful handle, with thumb hole. When it arrived I found someone had reprofiled the saw to a crosscut. I'm not sure how one uses that thumbhole for crosscutting. If you do reprofile a saw, you might want to first consider whether the handle is specific to the profile.

enjoy,

Dave

Re: "Saw speak" . . .

#6

Thumb Hole saws.......

Joe Rogers, Northern Virginia


>Could be ordered filed crosscut. It was a special order saw so you may have a "rarer" version if it has the same tpi as the stamp on the blade. I guess there is no telling if it is original though.JR

Re: "Saw speak" . . .

#7

Re: Suggestion for something not to do...

mikew


>Hi Dave,

Like Joe says, thumbholes could be bought as a cross cut.

The middle saw in the pic below is a 5 ppi cross cut made thatta way by George Bishop. It's a handy saw. I use it a lot. One of the ways I use it is for rough breakdown of sheet goods whenever I buy them. I use two hands, the thumb of my left hand in the hole and the palm over the top of the handle.

Take care, Mike


img

Re: "Saw speak" . . .

#8

Thanks guys

Dave Thompson


>I wouldn't have imagined the thumbhole would still be used in a helpful way without screwing up the kerf. Guess I'll have to give it a try again....

The D-8 I have appears to originally have been a 6ppi according to the stamp, though now it has a 11ppi crosscut profile, so no special find here.