Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

frame and panel construction

Posts

frame and panel construction

#1

frame and panel construction

Patrick Wheatley


>I am in the process of making a side board for my living room. It will be frame and panel construction and I have some questions. I have the legs and rails cut and sized and I am going to be marking out the groove for the panel tonight. It will be set back � inch from the edge, the groove it self will be �� by ��.

My question is, how do I go about making the groove in the legs. The rails are simple; I will use my 405 to plough straight through. The legs are a different matter, since it is a groove the starts and stops in the middle of the leg I am a little unsure what to do. Should I:

1. Define the edge of the groove with a marking gauge, then use the 405 to plough the groove extending the blade as I go. The problem I see is that the skates would get in the way on both ends.

2. Define the edges and use a chisel to cut the groove and then a router plane to clean up the bottom. The only thing I worry about with this method is not getting well defined walls for the groove.

Are there any other methods that I do not know about? I am sure I will be back with more questions; I am only at the beginning of my project after all.

Thanks for the help.

Pat

Re: frame and panel construction

#2

Re: frame and panel construction

Jamey Amrine in Ann Arbor


>Depending on the length, I would either create the ends with a chisel (probably a mortise chisel) with enough room for the rear of the skate to fit, and conect the ends with a plow, or I would do the whole thing with a router plane with a fence.

Really though, if the groove isn't terribly long, and there aren't several of them to do, I would just mark and pare with a mortise chisel. In this case, I would define the ends with short mortises and then pare between them.

I am sure there are many ways to skin this cat. Those would be the approaches I would try.

Re: frame and panel construction

#3

Start by drilling a hole or 2...

Scott Burr in Ben Lomond CA


>At the start and end of your groove. Then the plow blade has somewhere to start and finish.

Re: frame and panel construction

#4

Re: Start by drilling a hole or 2...

thomd coralseacat@yahoo.au


>I have used a chisel. What I hate about routers is using them where they chatter, do a bad job, force shapes on you. This is a situation begging for a fly cutter if you work in a mixed shop. Normally I can't unearth all my router parts so I am hand tools by default.

Re: frame and panel construction

#5

I don't understand the question ...

Ian (in Sydney, Australia)


>if the legs will be covered by the top why can't the groove just go to the top of the leg? working backwards from the top you could plow all but the first inch or so, which you could finish with a chisel

but the panel has a rail at the top and also at the bottom (?) which will attach to the legs via a mortise and tennon joint, so why not cut the panel groove from the bottom mortice to the top one?

am I missing some detail of the design here?

Re: frame and panel construction

#6

Re: I don't understand the question ...

Blaine Hollis


>I agree. It seems to me it's just a matter of creating a groove running between the mortises for the top and bottom rails. I suppose there are lots of ways to create this groove. Although I know I'm on the wrong side here, I just used my router to make the grooves in the legs on the sideboard I recently completed.


img