Late reply, my method
Dave Anderson Chester, NH
>Scott I sand to 220 grit for most woods including mahogany before starting the finishing process. I first put on an apron, eye protection, and nitrile rubber gloves. I then take a glass or plastic container (don't use metal it will corrode quickly with lye) and add a pint of water to the container. After adding the water I slowly add a heaping teaspoon of the Red Devil lye. Do NOT put the lye in the container and then add water, this can cause bubbling, frothing, and splattering and is a bit dangerous. ALWAYS ADD THE LYE TO THE WATER. I usually stir gently with a scrap of wood until the lye is completely disolved.
With a rag or a fully wet sponge generously apply the lye to the wood letting it soak in. Keep a wet edge and try not to overlap too much. Over the next minute or so the color will form and the piece will continue to darker and redden. Do not go over the areas where you applied the solution for at least 5 to 10 minutes as a reapplication will darken the wood still further. Let the wood dry for at least 12 hours. I then neutralize the wood with 3 caps full of white vinegar in a pint of water. Be very careful to dampen but not completely soak your sponge or rag. If your applicator drips onto the wood you will get nasty looking spots of discoloration and have to start the process all over again. I go over the wood with the rag only once being careful to get every area. Note that another contributor here, Sam Simpson, doesn't bother to neutralize at all and seems to get perfectly fine results. I've never tried it his way so I can't comment, but I'm more comfortable using the vinegar.
Finally I allow everything to dry for a full 24 hours before continuing the finishing process.