Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

I need a little help on sharpening!

Posts

I need a little help on sharpening!

#1

I need a little help on sharpening!

Charles Jackson III


>I sharpener my new hand plane blade, today with my new 800/4000 combo stone. but I am getting chips instead of shaveings and the plane is hard to push. I was trying to plane some old 2x4's. so what am I doing wrong.

Re: I need a little help on sharpening!

#2

Re: I need a little help on sharpening!

Moses Yoder in White Pigeon, MI


>If you are anywhere near the Indianapolis, IN area I would suggest showing up at Ray's Octoberfest on October 7th. I would show you how to sharpen a plane iron. Sharpening is not that hard, but until you have seen and used a sharp iron it is difficult to grasp the concept of how sharp a sharp plane iron is, and how easy it is to make it that sharp. Much has been written about sharpening in the archives here, and you can search for "sharpen plane iron" and sort through to find the good stuff.

Re: I need a little help on sharpening!

#3

Re: I need a little help on sharpening!

Bob Fawcett


>Are you sure you have the iron adjusted correctly?

Maybe the iron is taking to big a bite.

If you can, go as Moses said above.

Re: I need a little help on sharpening!

#4

Nice offer Moses

Joe in a Cleveland suburb


>Man. Sure wish I could go if for no other reason than that! Moses, I think I've mentioned this here before, but I get to the Topeka/Goshen area every so often. Next trip there, time willing, I'd like to try and meet you.

Joe

Re: I need a little help on sharpening!

#5

Re: I need a little help on sharpening!

Charles Jackson III


>Thanks Moses for the offer, I live in Alabama. I need to check my plane adjustment.

Re: I need a little help on sharpening!

#6

Re: I need a little help on sharpening!

Thom D


>Just withdraw the blade all the way, and then drop it down a bit at a time. That way you can sneak up on a fine setting, and you screw will be compressed, while if you move in the opposite direction you can dull the blade and have it shift through the backlash to a lower position. You may need to resharpen if you actually had it out and were hacking away, though usually one gets away with it.

4000 grit is usually not quite fine enough for really good results. You can get it sharp enough to work pretty well, indeed it was all I had with me this summer. But it isn't a really scary sharp edge.

Re: I need a little help on sharpening!

#7

Re: I need a little help on sharpening!

Todd from San Jose


>Hi Charles,

Are there any woodworking classes in your area? A Woodcentral perhaps? When I started out, I took a sharpening class and a basic woodworking course. Those two classes gave me a foundation to build my woodworking skills on. I later took a hand tools class that was the most interesting and informative of the three.

Classes can really give you the confidence that you're doing things right from the start.

Books and videos are also great, but there's nothing like hand's on experience in a class, with an instructor there to help you when you hit sticking points.

Todd

Re: I need a little help on sharpening!

#8

Re: I need a little help on sharpening!

William Duffield, on the Cohansey


>I assume you mean Woodcraft, for classes. If so, Charles' nearest is about a hundred miles.