LOL, the 4c Saga begins . . .
Steve Mackay
>Three days of WD-40 and the frog surrenders ! Down Boy !
Knowledge You Can Build On — Est. 1998
LOL, the 4c Saga begins . . .
Steve Mackay
>Three days of WD-40 and the frog surrenders ! Down Boy !
Re: LOL, the 4c Saga begins . . .
Moses Yoder in White Pigeon, MI
>Looks like a rosewood tote. I like to take a nice tote like that and clean it up good, laquer thinner or simple green will take the finish off. I set on a chair in front of the shop and listen to the birds while I sand it very smooth, up to 220 or 320 grit paper, then just put a few coats of BLO on it. I don't like to have a built up finish on them, becasue the natural wood just feels softer and warmer to pick up.
Same treatment for saw handle?
Martin Shupe
>Would you do the same to an old Disston saw handle? If not, how would you treat it differently? The one I have has paint and a rough finish on it.
I am following this thread for ideas...Thanks to both of you.
Re: Same treatment for saw handle?
Steve Mackay
>Like The Boss (no name, LOL !) said, did a couple Diston handles with paper then oil. Think I used 200 but might go finner next time. When I asked here at the time some one said the applewood was "like buttuh". He was'nt kidding ! Be carefull !
Re: Same treatment for saw handle?
Derek Cohen (in Perth, Australia)
>Be aware that oil will darken the wood. You may obscure interesting grain. A couple of coats of shellac may be better. Either way, sand to 320 (I have gone as high as 600), shellac or oil, then wax (first coat with 0000 steel wool) for a truly sensual feel.
Off for a cold shower..
Regards from Perth
Derek
Sensual feel...
Dan Moening in cooler Sacramento
>I completely agree. A couple coats of shellac buffed out by a wad of #0000 steel wool loaded in wax...oh baby, that's how a tool handle should feel.
~Dan