Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

?s on reforging an adze

Posts

?s on reforging an adze

#1

?s on reforging an adze

Dave Mount

>I've been wanting a full size adze with a mildly curved blade for a while but haven't been able to justify the expenditure. However, I have an adze head with a dead straight edge that's in good shape -- came in a $1 bucket of junk from an auction (minor gloat -- it's actually a little embarrasing, because I missed it in my initial scan and SWMBO bought the bucket for other reasons -- only later did I find the adze head!).

Per my message below, I've been messing around with forging and am thinking about reforging the blade of this adze into a shallow curve. Is it as simple as heating, reshaping, re-hardening, and re-tempering, or are there risks or steps I'm missing? I don't have a large top fuller, but I'm thinking that with an inside bevel, a few cross pein dings on the inside of the curve won't matter. For that matter, I don't have a suitable swage either, but was thinking of shaping something out of dense hardwood for a one-time use swage.

Any advice appreciated.

Dave

Re: ?s on reforging an adze

#2

Re: ?s on reforging an adze

Jim Crammond in Monroe, Mi.

>Dave,

I did this recently with Wes Groot's help, as in he did the work and I watched mostly. We used a swage block to get the curvature that I wanted and just used a hammer to pound the adze into the swage block. The hammer was probably about 3 pounds and had a curved polished head. I think hardwood would probably work, but it would char badly.

After it was curved, we re-hardened and tempered it. We also tried it with a grub hoe, but it cracked as it was cooling. I'm not sure if the curve was too extreme, blade was too thin or there was a prior defect in the hoe.

Good luck.

Jim

Re: ?s on reforging an adze

#3

Home made swage

Bob Hackett

>Just use a half section of pipe with an inside diameter of the curve you need.Weld a piece of strap down the center of the back so you can hold it in your vise.

Can`t find one the right size?Use a half section slightly smaller,place on floor and beat with a hammer till just smaller than what you need.After welding it should pull enough to be just right.If not use the vise to tweek it back to tolerance.

Mainely,Bob