Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Alternatives to #140 for dovetail rebate

Posts

Re: Alternatives to #140 for dovetail rebate

#26

Re: Answer To Mark's Question *LINK*

Norman (Metcalfe, Ont.)

>Hello Tom,Mark,

I have yet to experiment with the rebate trick, but I use the jig in the link below to keep the tail and pin boards registered correctly for marking purposes. It is easy to put together and gives fairly accurate results. It allows you to focus on marking and transferring markings instead of worrying about keeping the pin and tail boards aligned correclty. Very good registration is necessary when the pins are very narrow, as there is little room for error.

Also, I glued a strip of fine sandpaper under each caul to prevent any possible movement of the boards when paring and chiselling waste out.

Good Luck,

Norman


Dovetail jig

Re: Alternatives to #140 for dovetail rebate

#27

Re: Rob and the dovetail rebate

HC Sakman

>Hi again Derek,

There's no doubt or question that Rob is a great craftsman. I was not talking about anything in those lines. Well, as i mentioned above, I think the issue is already cleared up.

Your post sounded like I was misunderstood, so that's why I am writing this one to you.

It's all good.

Chico...

Re: Alternatives to #140 for dovetail rebate

#28

Re: What about a #95?

Marc in Luxembourg

>Sure the fence's not adjustable but a wooden one in the right thickness screwed to the integral fence works fine. The #95 has a skewed iron, is handy and fast. I think, it's a more current plane and is almost half the price of a #140. The width of cut is current to, so you do not always need an additional fence wood.

Marc

Re: Alternatives to #140 for dovetail rebate

#29

Re: What about a #95?

HC Sakman

>It sure does work well Marc. Good call. For nasty grain though, 98/99's lower angle is a little more accomodating.

Chico...

Re: Alternatives to #140 for dovetail rebate

#30

Re: Ok, secret was in the DVD...but

Cameron

>If it's the Allan Peters that I know of he was quite well known in the 1970's and early 1980's in Britain. He was written about quite extensively in various magazines and wrote quite a few articles in "Woodworker Magazine" at that time. Most of his furniture was expensive and high class. From memory he was always partial to using ebony in his furniture making - solid ebony tables, cabinets, bookshelves etc, as well as using lots of those old British wood stuffed "planers".

I guess he was the British equivalent of Krenov, fame wise.....But without all of the philosophical elements.