Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Fancy Dove Tail help request

Posts

Fancy Dove Tail help request

#1

Fancy Dove Tail help request

Greg Deavers in Stillwater

>Hi all,

Am wanting to try my hand at what I have to call "fancy" dove tails until you can teach me the correct terminology. TIA! First, I have gotten pretty good at "normal" dovetails so far on the projects I have done, so I understand the dovetailing part of the process.....

But, I have seen pictures of thin "pin" dove tails done in usually 1" or thicker materials where there looks like a 1/2 height pin is in between the full height pins, etc. A look that I would like to use in my current project. The "pin area" on the small side (angle) of the tail hardly looks wide enough to get a DT saw in there to cut out for the pin. Just stumped on this one I guess.

To date I have never found any articles or instructions on "HOW-TO" do this style of DTs. Could any of you point me in the right direction, or Splain the procedure.

Thanks for your input!

Re: Fancy Dove Tail help request

#2

Hounds Tooth?

Dan Moening in cool Sacramento.

>Are you describing Hounds Tooth Dovetails perhaps?

Here is the first link to a howto that I googled:

http://www.ukworkshop.co.uk/howto/joints/houndstooth_dovetails/index.php

~Dan.

Re: Fancy Dove Tail help request

#4

Yup! That's them, Thanks very much!

Greg Deavers in Stillwater

>