Re: Cock beading ? *LINK*
Adam Cherubini
>Its a seperate piece of wood, nailed in place. The question I had was how it was done. It was bent, not sawn. So was a form made and the pieces steam bent? The case could then be sawn to the bent pieces. I tried this and it didn't work. The pieces changed shape as they were mitered and it was a total mess. This also failed the sniff test. Jigs and fixtures don't seem to fit with early cabinetshops.
On my next attempt I scrolled the case, then bent the hot wet pieces to it. Again, not learning my lesson, I tried a caul to hold the beads while the glue set. Didn't work. There were tons of gaps under the beads. No amount of caul refinement seemed to work.
So I slathered the case with hide glue, and nailed the hot wet pieces in place splitting them just like the originals. I thought the splits were caused by 300 years of seasonal movement, but now I think otherwise. A few strategically placed pilot holes helped reduce the splits on the next piece.
The nails were flat heads or were filed flush on the originals. I left mine proud because I'm a hack.
Adam
cock beading