Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Sharpening a pair of Sheep Shears

Posts

Sharpening a pair of Sheep Shears

#1

Sharpening a pair of Sheep Shears

Ranbir Chawla, Castle Rock, CO

>I posted this earlier on the Power Tool section, but of course it makes sense to ask it here.

Due to a communication error at home, I'm stuck having to sharpen a pair of sheep shears instead of having them done by someone who knows what they're doing (Daughter has a sheep to finish hand triming before the Stock Show next week).

They look a bit like a pair of scissors, with the cutting edges meeting along the length of the bevel as you squeeze them. They come with plastic sharpening tool with a small stone inside, but that's not really good enough to put an initial edge on them.

I'm trying to figure out how far to take the sharpening process, and what the suggestions might be for getting into the top bevel. The flats I can do on a water stone, but because the blades are part of one piece of bend steel, it's hard to just work one at a time on a large stone.

I guess the question is do I want them to be smooth an sharp like a chisel, or with some 'tooth' on them like a kitchen knife. If anyone has any ideas, I'd love to hear!

Thanks in advance.

Re: Sharpening a pair of Sheep Shears

#2

Re: Sharpening a pair of Sheep Shears

Warren in Lancaster, PA

>I have the kind of sheers where the top and bottom blades are connected by a spring that forms the handle. Here's how I sharpen them.

Pull the blades apart a little and let the top blade go on the bottom. Then tie the handle pieces together so the sharp edges stick out at the sides. They will not stick out if you don't reverse the blades. This gives you access to the edges. I sharpen the blades at about 75 degrees on a sandstone grindstone. Any coarse stone will do. You do not want to refine the edge because the roughness catches the wool and makes it easier to cut.

Re: Sharpening a pair of Sheep Shears

#3

Re: Sharpening a pair of Sheep Shears

ThomD

>If the edges are soft enough to file, then file them with a mill bastard file.

Re: Sharpening a pair of Sheep Shears

#4

Re: Sharpening a pair of Sheep Shears

Ranbir Chawla

>That's kind of what I was wondering about, so a totally smooth edge wouldn't work well. I'll try this tomorrow night and see how it goes.

Thanks for the advice!

Ranbir Chawla

Re: Sharpening a pair of Sheep Shears

#5

Re: Sharpening a pair of Sheep Shears

paul womack

>Norton India fine slip stone. Easy to handle, and just the right grit to leave a smooth edge with "tooth".

BugBear (who's done this to sheep shears)