Hey Adam, How Does this Strike You?
Gary Stamper
>After the recent threads about the striking knife article I thought I would post a pic of the one I made. I used a file for the material.
Gary
Knowledge You Can Build On — Est. 1998
Hey Adam, How Does this Strike You?
Gary Stamper
>After the recent threads about the striking knife article I thought I would post a pic of the one I made. I used a file for the material.
Gary
Re: Hey Adam, How Does this Strike You?
Gary Stamper
>
Re: Hey Adam, How Does this Strike You?
ThomD
>Nice clean work"
Now that I am old I can see myself lunging in for a better view of the work, and driving that spike right out the back of my head! I did once cut the tip of my finger off with one of those. I was used to using this Japanese knife with a flat angle, like the one you made, and picked up one of their accute knives, there goes the my pointer!
Re: Hey Adam, How Does this Strike You?
Bruce, a MN Galoot
>Very nice! Is that single or double bevel on the edge?
Bruce
Re: Hey Adam, How Does this Strike You?
Gary Stamper
>It's a single bevel. I'm thinking of making one with a knife edge on both ends for marking dovetails. The blade here is .085" thick. I may bring it down .010 or .015" thinner. In use it feels very good in my hand. It will fit into a fairly small dovetail now.
Gary S.
Striking knife at Woodbutcher Tools *LINK*
Jack Guzman from Maine
>In October I made a trip up to LN headquarters.On my way back south on rte 1 I saw a sign for Woodbutcher tools.I had to check it out.It turned out to be a school for timberframing.They have a small very cluttered front room with miscellaneous tools and gadgets stacked haphazardly everywhere.I almost turned around until I looked closer.These were mostly quality woodworking tools of known makers.LN planes,japanese chisels,Robbins woodies,alot of things I don't remember.I noticed this tool in a box of odd stuff and had to try it.It comes with a too shallow bevel so it needs a little shaping but it has a nice feel with the knurled center section.The steel appears to be hard enough to hold an edge but mine sharpened easily.
I looked for it on their website and it isn't listed as far as I could tell but I'm sure if you contact them they'd sell you one.It was labeled as a scribing tool.
The website is shelterinstitute.com
Re: Hey Adam, How Does this Strike You?
Adam Cherubini
>Looks great! You may find it helpful to round the awl end.
Otherwise, I'm amazed at what you guys make. I wish there were blacksmiths beating these out. Its obvioulsy a beautiful little tool that woodworkers are interested in having.
Adam