Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Craftsman #46 clone and blades

Posts

Craftsman #46 clone and blades

#1

Craftsman #46 clone and blades

Joe Grittani

>I've been looking for a user Stanley #46 and the few I've seen were pretty expensive. I talked to a tool dealer this morning who says he has a Craftsman #46 equivalent without all the blades. I'm wondering if this might actually have been made for them by Stanley and if replacement blades for a Stanley would fit it.

I think St. James Bay makes replacement blades. Does anyone else? I'm going to look at it tomorrow.

Thanks for any help.

Re: Craftsman #46 clone and blades

#2

Jack Guzman from Maine

Jim Reed

Jack Guzman from Maine

>

Re: Craftsman #46 clone and blades

#3

Never heard of

Jim Reed @Tallahassee

>a Craftsman #46. Most likely it is a Craftsman version of the #45. Let me know if you need any blades. I just sent a batch out for heat treating and have started working on the next one.

Re: Craftsman #46 clone and blades

#4

Re: Craftsman #46 clone and blades

Joe Grittani

>Hi again -

Well, you know how it is. It wasn't a #46, it was a 45 clone with just the one blade that was installed. So Jim, you're probably right about no 46 Craftman clones. I'm still in the market for a complete user 46 or one complete enough that repro parts would complete it.

What a sad weekend. Not an old tool to be found anyplace I went. I Got the Bad Luck Old Tool Blues.

Thanks to those who responded. It's good to know that Jim Reed makes the blades for when I do need them.

Joe