Est. 1998 — 27 years of woodworking knowledge
I'm so close I can taste it.....
Ken Rozema - Whitby Ontario
>Here is my latest attempt at handcut dovetails. Cutting the tails first worked for me, or maybe I'm just getting better each time I try but these are not too bad. When I cut the pins I find it easier to mark since the cut is straight up / down.
There really is a certain sense of satisfaction to doing this.....SWMBO thinks I'm a nut.
Thanks for the advise a few days back, it really did help me.
Thanks
KenR
Nice!!
Victor Parisian
>
Re: I'm so close I can taste it.....
Richard A. Gillespie, Jr.
>Nice job! What are you making?
Re: I'm so close I can taste it.....
Ken Rozema - Whitby Ontario
>Thanks,
I'm not making anything right now. I had an old cutting board sitting in the shop so I ripped it in two and have been using to practise. When the DT is done I slice them off and try again. I'm running out of cutting board.....
KenR
Those look very nice.
Scott Burr in Ben Lomond CA
>Keep up the good work. Time to fine another cutting board eh...