Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Spoons

Posts

Spoons

#1

Spoons

dave caudill

>Here are the two spoons that I have carved from apple wood. I had no real plans or uses in mind other than a large spoon to stir a pot or pur out some soup. I just kind of eyeballed it so they are not exactly the same. Neither of these are the one I lost my $80 challenge on. That one is in the kindling box.

I'm going to go out this weekend and try and find some wood to participate in the new challenge that Pam suggested in the origianl post. I guess you can look at these and see what I had in mind.

One thing that I did find difficult during this process that I may or may not have mentioned was the difficulty in holding the spoon while working on it. This might be one of those places where a shaving horse would be real handy. Although the clamping system in the Gordon article that William posted a link to had a nice little system.

I look forward to hearing everyones experience that gives this a try. Should be fun.

Dave


img

Re: Spoons

#2

Re: Spoons

Greg B�tit, Vergennes, VT

>I haven't been following this forum too closely this week or I would have chipped in earlier. I make spoons when I want to putter in the shop, and don't feel inspired to do anything 'serious'.

I've made spoons out of things I find in the woods like grapevine (8" dia at the "butt'), lilac (ice storm knocked over a larger one a few years back), or branches of black walnut that are too small for much else. I quit bringing them in for my wife, she's got all she needs and then some. But I still make them.

I start by roughing the material (log) to something that can be held in the leg vise with saw and froe, side axe, etc. I flatten the top, then mallet and chisel out the scoop. Then I form the handle while the scoop is still thick sectioned, so that I can still clamp that end in the vise. I use a back saw and split off material to start, draw knife and spoke shaves to get it down to finished dimension. Then I turn it around and work the bottom of the scoop with draw knife and spoke shaves. I may switch back and forth to the shaving horse to get a better angle on the work at hand. Towards the end I keep a middle finger on the inside of the scoop as a guage to feel how close I'm getting to finish dimension.

I'll take some pictures for you- don't worry, they're nothing fancy.

Greg

Re: Spoons

#3

Re: Spoons

William Duffield, on the Cohansey

>Greg, if you haven't seen it already, look down the list for the thread, "Alone in the Garage", and consider participating in the one hour spoon challenge. It sounds like you've got a leg up on most of us.

Re: Spoons

#4

Re: Spoons

Greg Betit, Crown Point NY

>The ones in the back row are factory rejects. The one in the front row on the right half generally get used in the kitchen.


img