Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Follow up on Everlast chisels *LINK*

Posts

Follow up on Everlast chisels *LINK*

#1

Follow up on Everlast chisels *LINK*

Bill Houghton, Sebastopol, CA

>I own what I think is a GE Wood (ancestor of Stanley) Everlast chisel that's about 8-1/2" long. The oddity is that the blade is 1-3/16" wide at the cutting edge, tapering 1/16" back toward the handle. Were these in nominal sizes, or does this mean this was once much longer and 1-1/4" wide? I have been picturing making my fortune from this, and will be disappointed if it turns out to be clapped out.

By the way, people on this forum tend to refer to them as "Everlast," so I did just now (with the theme music from Rocky I through MCMVXII running through my head), but I note eBay refers to them as "EverlastING" (as in gobstoppers), and the one web site I found on their history (see link below and find link at left on chisels) uses the same term and even has what appears to be some catalogue copy on them using this term. So I guess we're mistyping in all our discussions.


on the chisels

Re: Follow up on Everlast chisels *LINK*

#2

Re: Everlasting

Moses Yoder in White Pigeon, MI

>Yep, just checked my catalog from 1934, and they are all referred to as "Everlasting". Must be we just shortened it to Everlast to save some letters. Can't use too many letters, we might run out. In 1934 you could buy a set of Everlasting #701 firmer chisels, set of 12 in a roll, for $21.70.

Re: Follow up on Everlast chisels *LINK*

#3

Re: Follow up on Everlast chisels

Todd Hughes

>I would bet that the chisel has been ground up, either to customise it for a job or to remove damage. The other week at the PATINA show I saw many everlast [ok everlasting!] chisels that were ground like this by dealers trying to pass off rusted junk chisels since the price of everlasts have risen. Actually the last couple I sold on ebay went for between $45-$80 which is down some from befor I think. Do have a nice red handle one up now that I have good hopes for. In my experance selling a few of these older pre Stanley chisels even though more uncommon they did not bring a premium and maybe even went for a little less then a regular Stanley everlast.Just my observation....Everlasting is correct as that is what they are called in the catalogs...now is it Bed Rock or Bedrock ?....Todd

Re: Follow up on Everlast chisels *LINK*

#4

Re: Everlasting

Tom Colligan, Peoria

>Moses, I just inserted your figures on the 'Inflation Calculator' site via google and the current cost would be $311 for a $21.70 product in 1934.