Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Marking Walnut

Posts

Marking Walnut

#1

Marking Walnut

Matt Malin

>What is the best way to mark the layout for dovetails in Walnut? I don't think a pencil is going to work too well.

Re: Marking Walnut

#2

Fine gel pen

Dan Donaldson

>

Re: Marking Walnut

#3

Marking knife

Michael R

>Make a marking knife (striking knife) out of scrap metal or buy from Woodcraft or another vendor. You'll get the finest, most accurate line I know of, and the line makes a physical guide for your chisel. It also cuts the surface fibers so you get al little less fuzz when sawing.

Re: Marking Walnut

#4

Re: Marking Walnut

GolfSteve in Calgary

>Here's what I do, assuming you cut the tails first...

Mark the tails with a RED PED. It really works. The red ink is easy to see on the walnut.

Then mark the pins with a marking knife as usual. Use a bit of white chalk to highlight the knifed lines.

Re: Marking Walnut

#5

Re: Marking Walnut

Paul in NJ

>Use a marking (striking) knife and rub a little chalk in.

Paul Dzioba

Re: Marking Walnut

#6

What Michael said!

Alan Hamilton

>

Re: Marking Walnut

#7

The Official WC Sir William Endorsed Marking Pen

Don Thompson - Cutler Ridge, Florida

>... is a Pilot P500.

Re: Marking Walnut

#8

Re: The Official WC Sir William Endorsed Marking P

William Duffield, on the Cohansey

>Credit should go to Bill Tyndall, who did the basic research and announced his findings here first.

A couple of warnings: The Pilot is not suitable for rough sawn lumber, which will often break the tip off. It is also not suitable for softwoods, which will just gum up the ball. I did those bits of research myself.

Re: Marking Walnut

#9

Re: Marking Walnut

Clay C in Miami

>Having done lots of walnut-marking lately, I'd agree that a knife (with the line 'filled' with chalk or a yellow artist's pencil) is probably best. I've also had some success sticking some of the light-green tape on the surface, and then just marking on the tape.

Clay