Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

H & R Follow-up Question

Posts

H & R Follow-up Question

#1

H & R Follow-up Question

Doug Reynolds in Seattle

>We know that hollows and rounds are of a standard height and length and, the table provided below provides, quasi-standard numbering systems for diameter of circle being cut. Is there a standard for the width of the plane consistent with the width of the iron i.e., is the plane width always iron width plus 1/4 inch? I have Todd Herli's video and he gives blade deminsions but, not plane width dimensions.

Re: H & R Follow-up Question

#2

Re: H & R Follow-up Question

William Duffield, on the Cohansey

>There is no "standard", in that the makers do not need to conform to one, nor is there a mark that would be put on a plane that showed that it complied to a standard.

The convention, usually followed, is that the arc is 60�, so that the width of the iron is equal to the radius.

I'm warning you however, that you are thinking like an engineer, which is not necessary, :^) Remember that these planes are for making "look good" surface details, not for machining joining surfaces that must fit perfectly to another surface.

Re: H & R Follow-up Question

#3

Re: H & R Follow-up Question

Wade Mackey

>You also need to add ~1/4 for the back side of the plane, so the total width would be width of the blade + ~1/4".

Wade Mackey

Lancaster, PA

Re: H & R Follow-up Question

#4

Re: H & R Follow-up Question

William Duffield, on the Cohansey

>I don't think there are any standards for the width of the supporting side of the plane, either :^) That's an interesting point, however. Should we be measuring the width of the sole or the width of the iron itself?

And then there is the issue of the width and angle of the arc of the mother plane that the planemaker uses to shape the soles of the hollows and rounds. It's blade should be 1/4" or so wider than the blades of the planes that the cabinetmakers use.