Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

A crooked man with a crooked bevel

Posts

A crooked man with a crooked bevel

#1

A crooked man with a crooked bevel

Andrew in Plano

>I bought a 1/2 inch mortise chisel off EBay. Everything is fine except that the bevel isn't square to the chisel. I don't have a grinder or anything like that, just a few waterstones and of course sandpaper. I have a couple of blade holders for sharpening, but I don't see how I can square up the bevel with that. Any suggestions?

Peace

Andrew

Re: A crooked man with a crooked bevel

#2

Re: A crooked man with a crooked bevel

David Miller from Iowa

>I'd start with a file and get it in the ballpark, then go to scary sharp and coarse sandpaper. It's tedious and uses a lot of sandpaper, but does work.

Good luck, David

Re: A crooked man with a crooked bevel

#3

Re: A crooked man with a crooked bevel

Sandor in Boyds, MD

>No grinder here either.

Just get some of the Norton blue Zirconium sanding belts 120 grit at Home Despot and double stick tape them (carpet tape) to a relatively flat board. Use your honing jig and you'll be suprised how fast the metal will come off. Be sure to vaccuum or brush off the swarf to facilitate cutting. I can get maybe a half dozen chsels or plane blades done on a belt before its worn. Its not hollow ground, but it'll shape up the edge ready for honing.

Re: A crooked man with a crooked bevel

#4

Well you could...

Scott Burr in Ben Lomond CA

>mark a stright line across the blade with a sharpie of equlivent marker and attack it with a belt sander. Otherwise get ready to do the same thing by hand sanding on sandpaper then go to the guide for final squaring and sharpening. Good luck, sounds like a nice workout.

Re: A crooked man with a crooked bevel

#5

use a magnet to clean swarf

Gerry Doll

>

Re: A crooked man with a crooked bevel

#6

Re: Well you could...

Andrew in Plano

>So are you guys saying to hold it vertical and square up the end, and then re-shaping the bevel? That will be a workout.

Peace

Andrew

Re: A crooked man with a crooked bevel

#7

Re: Well you could...

Scott Burr Ben Lomond,CA

>Try to maintain the bevel as you square it. Less of a workout that way. I hope I'm making sense here...

Re: A crooked man with a crooked bevel

#8

Re: Well you could...

Greg Sloop, Portland Oregon

>I don't think it makes any difference either way. (Unless I'm really off on my geometry...)

Either way you'll take off the same amount of material, provided you don't over-grind while it's vertical - which it's easy to do. But theoretically and all... *grin*

Cheers,

Greg