Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Beginner Advice for Building a Mallet *LINK*

Posts

Beginner Advice for Building a Mallet *LINK*

#1

Beginner Advice for Building a Mallet *LINK*

Jake J. (Windsor, Ontario)

>Hi All,

2 Questions:

1) I have red oak, maple and mahagony, enough of each to make a mallet. Are any of these a suitable material for such an application? None are quarersawn, they are all boards from Home Depot, so you can guess how they were cut (flat sawn probably?). I know I should use beech or others, but this is what I have.

2) What aproximate angle should the face be cut on? I'm thinking about a design similar to the link below found on the Lee Valley site.

P.S. On my first post I said I'm starting my(Bob Key style)bench, I've got a few boards glued up and most of the top cut. Now I have to start on the base.


Making your own mallet

Re: Beginner Advice for Building a Mallet *LINK*

#2

Re: Beginner Advice for Building a Mallet

Pat Riley

>I have made several mallets that way. 3 different sizes.

I have used a 7 degree angle from verticle on each of the faces and have been very pleased with it. For the angle on the handle wedge I use between 3 and 3.5 degrees per side.

Re: Beginner Advice for Building a Mallet *LINK*

#3

Re: Beginner Advice for Building a Mallet

Frank D. in Montreal

>Hi Jake,

I used maple on a mallet I made; it's my favourite mallet and has held up quite well to severe whacks on all kinds of stuff. I used stair tread cutoffs. I copied a European mortising mallet for the angle of the faces: 5�. My mallet is a Frankenmallet, when I use it on a job site I get all kinds of snide remarks, but it's so comfy I can use it for a long time without getting tired. The handle is a 2x2 shaped with a spokeshave (in five minutes...). Not for the faint of heart.

Frank


img

Re: Beginner Advice for Building a Mallet *LINK*

#4

Re: Beginner Advice for Building a Mallet

Chad Boehlke

>Hi, I have used a Mulberry head on an oak handle for about 10 years. The faces now have to be cut off. Both faces are square, but I have bult a new one from scrap maple and the handle is an old spindel from a chair. Don't spend any money on a tool that will be beaten up.

Re: Beginner Advice for Building a Mallet *LINK*

#5

Re: Beginner Advice for Building a Mallet

Pam Niedermayer - Austin, TX

>You probably want to be sure and make the hammering faces end grain, which gives you the greatest compression strength.

Pam

Re: Beginner Advice for Building a Mallet *LINK*

#6

Re: Beginner Advice for Building a Mallet

Ernie Miller Topeka

>Maple would probably be better but best of all would be a tree branch that fell in you yard otr the neighbors that has been riven into the aproperate thicknesses. The mahogany should work the Oak might split but will make a good handle.