followup on smoothing inside curves
bill tindall
>I borrowed a LN shave to try on this problem and the results explained the divergence of opinions I got for an earlier post. This and the LN look-alike turned out to be high angle shaves not greatly unlike my old stanley in terms of cutting action, but quite nice in fit and finsh. I found that it (1) could not track a tight curve(2-3") and (2) it didn't shave near-end grain in an inside curve very well. For more shallow curves it was great, but my homemade shave handles these just fine, and as a low angle handles shallow curved end grain better. So, it looks like for anything but moderate sloping inside curves that the rasp, file or abrasive approach is necessary, as suggested by some of the Forum participants. Thanks again for all the input.



