Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

crown plane fettle

Posts

crown plane fettle

#1

crown plane fettle

Mike Real

>Help! I just got a crown plane panel raiser from ebay and the blade will not hold. I will get it set and tap the wedge to hold it and it slips as soon as I start cutting. Blade is sharpened and I am just taking a fine cut on plane pine, but the blade slips up into the plane after two cuts. Only way I can keep cutting is if I hold my thumb on top of the wedge. Suggestions?

Mike in Pittsburgh

Re: crown plane fettle

#2

Re: crown plane fettle *LINK*

Greg B�tit, Vergennes, VT

>Sounds like a geometry issue- wedge not at the correct angle or something. I have a matched pair of their panel raisers and neither have behaved as you describe. If I were you I would contact Crown Plane and see what they recommend.

Greg


Crown Plane

Re: crown plane fettle

#3

Re: crown plane fettle

Rob Lee

>Hi Mike -

If the plane wedge has been waxed or buffed - that may be part of the problem...

You may want to consider roughing up the contact surface a bit (wedge and body)...

Slip a fine sandpaper between the wedge and body, and sand very lightly... turn the paper over and repeat...

Cheers -

Rob

Re: crown plane fettle

#4

Re: crown plane fettle

paul womack

>If the plane wedge has been waxed or buffed - that may be part of the problem...

You may want to consider roughing up the contact surface a bit (wedge and body)...

I like the diagnosis - it's quite likely that someone wanted toi "improve" the plane for Ebay.

I'd try wax removal (with solvent) before anything more aggressive though.

Don't forget to dewax the blade as well.

BugBear

Re: crown plane fettle

#5

hmm...

Christopher Fitch @ Memphis

>that might explain some issues I have had with my Harris tools panel raiser..

I had a bear of a time getting the wedge to stick... I had to work on the wedge to make it fit between the blade and body.

I'll have to rexamine that avenue.

Re: crown plane fettle

#6

Re: crown plane fettle

Mike Real

>Thanks guys, the bottom of the wedge is shiny, maybe wax, I'll try roughing it to see if it helps. Tried shimming without luck, did put a straight edge on the bottom of the wedge and theres light in the middle, looks like its just bearing on the edges. I'll try some strokes on the scary sharp glass plate to try flattening while I rough it. Essayons

Re: crown plane fettle

#7

Call Leon Robbins

Greg Earley

>HI Mike

When you bought the plane off ebay was it purchased from Sportsmanmart. If so those planes are made by Leon Robbins former owner of Crown Plane. Before you do any modifications to the wedge call Leon directly and he will be more than willing to direct you in what to do. I called him and he said to give him a call at 204-443-4183. He is wonderful to talk to.

He is still selling planes I buy at least 2 to 3 a year and love every one of them.

Greg

Re: crown plane fettle

#8

Rats phone number wrong

Greg Earley

>Leons phone number is 207-443-4183

Sorry guys

Greg Earley

Re: crown plane fettle

#9

Re: crown plane fettle

Mike Real

>Well guys, I tried roughing and flattening and she still pops out. The horns of the wedge seem to extend all the way to sole and actually stick out on the left side. I hesitate to change any geometry here but it looks like I need to trim the ends of the wedge back because they are catching on the wood being planed and are forced back. Suggestions?