Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

21 Gauge Pin Nailers

Posts

21 Gauge Pin Nailers

#1

21 Gauge Pin Nailers

Hank Knight

Anybody using a 21 gauge pin nailer? If so, how do you like it? I have a couple of 18 gauge brad guns that I use a lot and a 23 gauge pinner that I never use. I like the idea of the pinner's tiny entry hole, but they are designed for holding stuff in place while glue dries, not for nailing stuff down. The new (relatively) 21 gauge pin nailers seem like a great compromise between the 18 gauge brad and the 23 gauge pin - small hole but with a little head on the brad that increases it's holding power. I'm thinking about buying one, but I'd like to hear from those of you who have used them.

Thanks.

Re: 21 Gauge Pin Nailers

#2

Re: 21 Gauge Pin Nailers

William Duffield

IMHO, the only viable alternative to a 23 Ga. headless pin nailer is Titebond No-Run, No-Drip Wood Glue and blue tape. You WILL see the nail hole left by the 21 Ga. brads, and will then need to go back and fill and sand the holes. This always seems to happens when the piece needs to be delivered yesterday.

Re: 21 Gauge Pin Nailers

#3

They fasten plenty of stuff here

Bill Tindall, E.Tn.

"they are designed for holding stuff in place while glue dries, not for nailing stuff down. "

the pins are coated with hot melt adhesive. Friction melts going in and there forever. They are near impossible to extract from hardwood. I use mine for fastening molding.

My problem is my Porter-Cable leaves a dent. Are there nailers that do not?

Re: 21 Gauge Pin Nailers

#4

Re: They fasten plenty of stuff here

Garthinsandiego

Had the same problem. Use a small piece of hardboard under the nailer to prevent denting. Been several months so not sure what thickness is required.

Re: 21 Gauge Pin Nailers

#5

Re: They fasten plenty of stuff here

Barry Irby

Some guns have little rubber protectors available. They snap on. Work well if you can get one.

Otherwise, try wetting the little dent. May swell it back up and help close the hole. Spit works well, but don't ask how I know that.

Re: 21 Gauge Pin Nailers

#6

Re: They fasten plenty of stuff here

David Weaver

I had an expensive grex gun that didn't leave a mark and buried the pins a little.

I also have a cordless ryobi now (I don't pin stuff often enough to keep the grex and don't have the compressor running all the time) that leaves the pins flush without mark, but it doesn't bury them as well.

All things considered, good, but the trade off for lack of air is a big tool with a heavy battery on it (not handy for tight spaces - the weight is forgivable).

Love the tiny pins, though.

Re: 21 Gauge Pin Nailers

#7

Grex

David Yoho

I agree with your results of the Grex pinner. Mine doesn't leave a mark.

Re: 21 Gauge Pin Nailers

#8

Thanks ordered the Grex

Bill Tindall, E.Tn.

I have been looking for a worthy cause for my virus check from the government. I use my pin nailer frequently but didn't like its dents.