Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Chisel sharpening question

Posts

Chisel sharpening question

#1

Chisel sharpening question

Barry Irby

I recently picked up a Veritas MKII honing guide at a tool auction.

I have never bothered to actually measure the angle I sharpen at. I just did what looked right.

Now that I have the little angle gauge I checked and they are right at 30 degrees.

Is that good? What angle do you use? (These are general purpose chisels, maybe bench chisels. I am snicking up on doing some dovetails.)

Re: Chisel sharpening question

#2

depends on the steel and application

Bill Tindall, E.Tn.

There isn't one answer. Some steel holds up better. Some applications involve more stress. Sharpen at the steepest angle that provides acceptable edge longevity.

Re: Chisel sharpening question

#3

Re: Chisel sharpening question

Bruce, a MN Galoot

30 degrees is a good enough starting point. Adjust accordingly, what Bill T describes

Re: Chisel sharpening question

#4

Re: Chisel sharpening question

Hank Knight

Almost all of my bench chisels are older carbon steel ones - Witherbys, Swans, etc. I sharpen at 25 degrees. I used to use a micro bevel of a couple of degrees, but I don't do that anymore - it's easier to just touch up the full bevel freehand. I find 25 degrees gives me good penetration without crushing fibers and it is a good angle for paring. I touch up my edges on an 8K stone and/or a strop regularly, but I haven't experienced much edge deformation or chipping at 25 degrees. I also have a bunch of Japanese chisels that I used on detail joinery. I've never measured the angle of the bevel on those, but it appears to be about 25 degrees as well. sharpen them the same way I sharpen my western chisels, except I use water stones instead of the oil stones I use on my Western chisels. Again, I don't get chipping or deformation of the edges on those either.

Re: Chisel sharpening question

#5

Caution

Jerry Gibbs

When using that guide, make sure the edge is square to the centerline of the chisel. If the sides of the chisel are tapered, don’t put the side against the edge of the guide. You will quickly learn.

Re: Chisel sharpening question

#6

Re: Chisel sharpening question

Bill Tindall, E.Tn.

After chopping out dovetail waste in walnut with a 25 degree chisel examine the edge under magnification and report back. I predict the edge will look like somewhere between the Sorby chisel edge shown in the picture (worst steel I have evaluated) and a LV PMVII which is qualitatively the same but quantitatively less deformation.

Forces on the tip when paring are much less and the edge may just round over by abrasion under this condition.