Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Craftsman TS Motor Fail

Posts

Craftsman TS Motor Fail

#1

Craftsman TS Motor Fail

Mark

After 20+ years my table saw motor 1.5hp/3450 rpm has failed.

It starts to turn very very slowly before stopping, humming ,and tripping the breaker in my electric panel .

There appears to be a reset button on the side but it does not overcome the issue.

Any guesses as to what the problem might be with it ?

This is my first experience with an electric motor fail on a power tool.

Generally (without knowing the exact issue), are these worth repairing or does it likely need replacement?

Thanks

Re: Craftsman TS Motor Fail

#2

Re: Craftsman TS Motor Fail

Keith Newton

Sounds like a start capacitor to me.

Re: Craftsman TS Motor Fail

#3

Re: Craftsman TS Motor Fail

Chuck

OR the centrifugal switch needs to be blown out to get rid of the saw dust

Re: Craftsman TS Motor Fail

#4

Re: Craftsman TS Motor Fail

Bruce, a MN Galoot

I had the same problem with the centrifugal start switch on my TS motor. A occasional cleaning did the trick.

Re: Craftsman TS Motor Fail

#5

Re: Craftsman TS Motor Fail

Don Evans

Some of the older Craftsman saws had a direct drive motor setup.

So does this say have pulley on the motor and belt?

Or does the blade mount directly on the motor shaft like the one I had.

Point is, only the one using belts would have a centrifical switch.

If it is the direct drive type I don't know anything you can do to it other than replace it.

You might try www.surpluscenter.com I have seen them on that site for sell.

Re: Craftsman TS Motor Fail

#6

Re: Craftsman TS Motor Fail

Walter Ahlgrim

The first thing is does the motor turn freely or is it binding?

Walta

Re: Craftsman TS Motor Fail

#7

Re: Craftsman TS Motor Fail

AZ in Colorado Springs

My Craftsman contractor TS is about that old. I got it used 15 years ago. It does NOT have a TEFC motor, so saw dust gets inside and clogs up something or other and needs to be cleaned out. I've taken the motor to a motor shop and they get it going. It's likely not the start capacitor. The shop charged me about $60 bucks for this. They recommended installing a TEFC motor, but that was going to cost about $300, so I deferred that decision to next time.

Well, the saw cost me only $50, so I'm making up the cost in maintenance.

Re: Craftsman TS Motor Fail

#8

Before you switch to a TEFC motor

Keith Newton

You might find that when the blade is tilted over to 45º that the fan housing is above the table. This may not be a problem ripping narrow lumber, but prevents mitered corners on plywood cabinet ends, or other architectural elements where that is common.

Re: Craftsman TS Motor Fail

#9

Capacitors

John in NM

Most of that charge is labor - start caps are typically under $10 if you want to do it yourself. McMaster-Carr carries them, as well as other similar suppliers (they do not require you to be a business as Grainger does or used to - haven't bought through Grainger in years so I don't know if they still have that policy).

Re: Craftsman TS Motor Fail

#10

Re: Capacitors

Keith Newton

Yes, Ive changed out several and it seems like about $8 was the price.

While I've never been shocked by one, I think you can get quite a jolt if you make a direct short with your fingers, so be very cautious, do a google search or ask someone that knows to show you.