Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Gluing to TS grid wing Question

Posts

Gluing to TS grid wing Question

#1

Gluing to TS grid wing Question

Barry Irby

I have a 40+ Delta Rockwell contractors TS that has grid wings. About ten years ago I got a Beismeyer fence that rests on the table. I covered the grids with Formica. Sanded the surface lightly and used contact cement. Worked well, but recently it has started to turn loose and is slightly lifted on the corners. It's getting looser. The wings are zinc or some sort of pot metal.

I suspect the tarnish has worked it's back into the joint and caused the contact cement to fail. Other than doing it over with contact cement any suggestion on a more permanent fix? Better adhesive?

Re: Gluing to TS grid wing Question

#2

Re: Why glue?

Henry (Raleigh NC)

Barry

Why glue it? Why not make a few blocks to fit into the grid - the same thickness/depth as the grid. Attach the top to the blocks with screws. Attach a few other pieces at the bottom so it won't lift.

Ought to take care of a few of those pieces of scrap I have read about.

Henry

Re: Gluing to TS grid wing Question

#3

Contact cement is not a long term adhesive

Dick Coers

Maybe first you could try reactivating it with a little lacquer thinner. Next time I would use silicone. Lay a flat piece of MDF on the new piece and add weight to squeeze out excess and make it flat.

Re: Gluing to TS grid wing Question

#4

Re: Contact cement is not a long term adhesive

George Koch

It only last 50 to 60 tears on old formica countertops!

Re: Gluing to TS grid wing Question

#5

Re: Contact cement is not a long term adhesive

Dick Coers

I knew someone would use an old countertop analogy. But I bet it doesn't by the sink if water gets at the particleboard.

Re: Gluing to TS grid wing Question

#6

Re: Contact cement is not a long term adhesive

Don Stephan

Countertop substrate is a continuous surface, not a grid, and not subject to the same lateral stresses and vibration. Still, a good comparison.