Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Delta Drill Press Woe

Posts

Delta Drill Press Woe

#1

Delta Drill Press Woe

Tom Norton

I have a model 17-900 that is in need of a new spindle. But alas it is an obsolete part. I have been searching and am not able to find one.

Any chance someone here might know where one is hiding???

Otherwise I am afraid the unit will be heading to the landfill.

Re: Delta Drill Press Woe

#2

Re: Delta Drill Press Woe

Dick Coers

What failed on the spindle that causes it to be scrap?

Re: Delta Drill Press Woe

#3

Re: Delta Drill Press Woe

Tom Norton

Took the spindle to the local NAPA to have the bearing pressed off. Both of us were sure of the direction that the bearing was installed. Both of us were wrong. There was a very loud bang!

Re: Delta Drill Press Woe

#4

That'll do it!


Re: Delta Drill Press Woe

#5

Re: Delta Drill Press Woe

John C Lucas

Can it be welded.and remachined.

Re: Delta Drill Press Woe

#6

Maybe try Grizzly *LINK*

Dick Coers

They list the internal taper on the parts lists, and bearings show the industry number, so maybe you will get lucky. I also found this note on one of the parts lists for the Delta part. I think I would start with this one. Does your machine have that taper adapter in it?


http://cdn1.grizzly.com/partslists/g7948_pl.pdf

Re: Delta Drill Press Woe

#7

Re: Maybe try Grizzly

Tom Norton

I will take a look tomorrow to see if that adapter is present.