Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

My favorite oversized pressing technique

Posts

My favorite oversized pressing technique

#1

My favorite oversized pressing technique

Dick Coers

Seeing cement blocks used for veneer pressing, I thought I would share a technique. When I'm up against a difficult oversized pressing, I use the ceiling joists in my shop. I make a caul to cover the layup, then cut 1x4s to wedge up against the ceiling joists. I cut them about 1/4" to 3/8" long, then bow them into place. If you don't have a big enough, or flat enough bench, I make an egg crate style assembly on the floor. I use 3/4" particle board and rip into 11" strips. I then cut vertical half laps in it and basically make a dry fit torsion box interior. This bridges across any out of flatness in the floor and I get a nice flat, no twist top.

Here is a pic of the first project I used this with. I ordered the diamond ribbon strip mahogany top, laid up on 3/4" mdf. Then built a torsion box interior, and 3/4"mdf bottom layer. The unusual aspect of this piece was the client wanted a minimum base under it, plus be able to have computers inside. I had a steel angle iron substructure built and anchored that to the concrete floor. We slid the base over it. Each end of the base has a door. Before the top glue up, I fixed steel plates with bolts welded to them between the torsion box webs, and screwed to the bottom skin. Drilling templates were made to transfer the holes into the angle iron. It was a big challenging project. We did several pieces for that office remodel in the hay day of my custom woodworking business.


Re: My favorite oversized pressing technique

#2

Ellis Walentine

Very nice!

Ellis Walentine

That takes me back to some similar jobs we did back in the 80s -- big dining tables, conference tables, etc., though I must admit that when I needed a large veneer layup, I'd go visit a buddy who had a 5 x 9 Belgian hot press. That said, your go-bar routine (Or "jo-pokes" as my friend in western Canada calls them) is a time-honored way to exert pressure where clamps fear to tread. I installed a fake marble vanity top recently using this exact method. I did find a good improvement on the technique: Make a skid plate from a slick piece of wood, spring your go bar on to it and then tap the skid plate in to bow the pole. It's easier and more forgiving than trying to skid the end of the pole itself.

Ellis

Re: My favorite oversized pressing technique

#3

Alan Young

Re: My favorite oversized pressing technique

Alan Young

Great piece Dick-

You mentioned in your post:

I ordered the diamond ribbon strip mahogany top, laid up on 3/4" mdf.

I assume by ordered you meant you put in order the veneer pattern-or did you literally order the top from another source?

and back to the edgebanding protocol-did you put that solid (2"?) edge on the torsion box first-then set the top and trim?

Problem solving -Expert Level!