Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Knock Down Hardware for a Dining Table

Posts

Knock Down Hardware for a Dining Table

#1

Alan Young

Knock Down Hardware for a Dining Table

Alan Young

I've been working on a Trestle Table in the Dutch Pull out fashion:


I want the bridge section and its associated stretchers to be removable so I made some knock down hardware for it.

These brass pieces are designed to be inserted in the end of the bridge piece that connects the ends.




Threaded insert goes into the end


It''s alignment hole lines up with the bridge hole


A 1/4-20 brass screw and turned bushing go through one side


and tighten to a turned tapped bushing on the other side



The bridge can then be joined to each end piece with a 3/8 inch bolt



There are then two more boards that connect the the tops at each end. This is the hardware used for this connection


the long rails are mortised out to accept two 3/8 bolts with washers and nuts


The outside of the end piece with the heads of the 3/8 bolts


Everything connected




-Alan

Re: Knock Down Hardware for a Dining Table

#2

Clint Searl

Re: Knock Down Hardware for a Dining Table

Clint Searl

An IKEA-worthy design. Most imaginative.

Re: Knock Down Hardware for a Dining Table

#3

And look at...

Mike Farinella

the money you saved on glue. Nice work Alan.

Re: Knock Down Hardware for a Dining Table

#4

Re: Knock Down Hardware for a Dining Table

Dick Coers

When I see a substructure like that, my usual comment is "You could park a pickup truck on that". And I think you could with this one for sure. I do wonder about the need to use a bolt to retain the threaded bar. Wouldn't just a pin do the same thing? I did think that wood movement may just let the pin rattle during the winter though. Quite the engineering effort, congrats!

Re: Knock Down Hardware for a Dining Table

#5

Alan Young

Re: Knock Down Hardware for a Dining Table

Alan Young



I do wonder about the need to use a bolt to retain the threaded bar. Wouldn't just a pin do the same thing? I did think that wood movement may just let the pin rattle during the winter though.

Good thoughts Dick-

I have played with this arrangement in some previous pieces and have both just pinned them or used a tapped arrangement. Here the 1/4-20 screw acts as a loose pin going through the 1/2 threaded rod-but the oversized bushing and the tapped bushing for the 1/4-20 screw have a 1/2inch small diameter where they are interested into the walnut- they have a fairly tight fit.


Every exposed bolt will be covered by a removable plate-probably brass but maybe walnut-So the bolts can be tightened if necessary---