Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Stock prep/Planing question.

Posts

Stock prep/Planing question.

#1

Stock prep/Planing question.

Barry Irby

I have some air dried cherry I am about to use to build furniture. Several boards about 8" to 9" wide are cupped maybe a `1/4" across the width. How do you handle this?

I know to cut the stock down to smaller pieces. How about ripping it and gluing it back flatter? What do you suggest?

Re: Stock prep/Planing question.

#2

Re: Stock prep/Planing question.

Brian Holcombe

1/4" is a pretty decent cup, I'd probably rip them into smaller pieces. If not, working the convex side can sometimes reduce the overall cup.

I've never noticed any other way to take out cup as a perminant solution, only surfacing or ripping down.

I've used steam on thin stock to remove a bow, so something to keep in your toolbox for future issues.

Re: Stock prep/Planing question.

#3

Re: Stock prep/Planing question.

AZ in Colorado Springs

I'd rip them, flatten the two narrower boards, then square up the edges and glue them together. You can probably make the seam close to invisible.

Re: Stock prep/Planing question.

#4

Re: Stock prep/Planing question.

Bill Tindall, E.Tn.

That is an astonishing amount of cup...unless one side is sap. Cherry boards with sap on one side can make troughs. When planing cupped lumber run the first pass with the cup up (convex side up) until it is flat enough to not teeter when flipped.

Most cabinetry has a side that doesn't show- sides for example. I clean up the convex sides and turn the boards concave side in if they don't clean up at my preferred thickness. If it is an occasional board use it where narrower pieces are required.

I'm not fond of ripping wide boards and regluing. But then I am way picky about grain presentation on my stuff.

Re: Stock prep/Planing question.

#5

Re: Stock prep/Planing question.

Mark Hennebury

First thing that i would do is to see if your lumber is at equilibrium; Cut a couple of inches off the end, re-saw it (grain vertical) in half on the band-saw, and see what happens. If it stays the same shape then your wood is stress-free and you can continue to face and thickness, but if it changes shape then you have stress caused by uneven moisture distribution, and you would need to deal with this prior to doing anything else.

Re: Stock prep/Planing question.

#6

Thanks.....And

Barry Irby

I think Bill is correct...I have not sorted and examined these pieces thoroughly, but I did see that the worst pieces had sap on them.

And Mark, that's a good idea. I will test the equilibrium. I am nearly sure it's OK but it can hurt to check. This stuff has been in my Greenhouse/Kiln for years. This is a solar heat type greenhouse attached to my house, not suitable for growing plants but at times it can produce enough heat to kill off insects in the wood.

I want to prep this stock and let it sit indoors for a while before going further. Time to equilibrate a bit with the indoor conditions.