Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Bearing Equivalency

Posts

Bearing Equivalency

#1

Bearing Equivalency

Don Stephan

The lower thrust bearing on my bandsaw doesn't spin well anymore. It is labelled "6200RS." Grainger's search returns "6200 2RSL/C3 PRX." Would the Grainger bearing be an acceptable substitution? Service Dept at Carter Products has not called back,

Re: Bearing Equivalency

#3

Re: Bearing Equivalency *LINK*

John in NM

6200 is the size and type -- 6 = standard single row deep groove, 2 = light duty, 00 = 10mm bore.

RS is rubber seal, typically they are marked 2RS for rubber seals on both sides (double sealed). ZZ is a shielded bearing, not as good at keeping dust out and grease in, but they do tend to have a higher speed rating.

For bandsaw guides go for cheap and replace as needed. There is no keeping that level of dust out!

VX Bearing has about the cheapest available... Made in China usually, but for this you don't need a high dollar fancy bearing.


VX Bearing

Re: Bearing Equivalency

#4

Re: Bearing Equivalency

TomD

That is great info.

In the cycling world sealed bearing are popular on hubs for mountain bikes as they are, well, sealed. But some folks have pointed out the sealing is to keep the lube in , not to keep the crud out. Apparently an issue in motors where blowers can lower pressure and suck the lube out. Hey, that is the story.

Re: Bearing Equivalency

#5

Re: Bearing Equivalency

John in NM

Seals are meant to do both, as are metal shields, they are just optimized for different tasks - seals are better at excluding dirt and retaining grease, shields are better for high rpm applications. Both operate on the assumption that bearings will be changed at some, perhaps many, points in the machine's lifetime.

I don't buy the low pressure line :D That probably came about by assuming that bearings are forever and need no servicing/replacing... based on that mistaken assumption, one would need an explanation for fan bearings failing. It takes a bigger pressure drop to move grease than a fan would be capable of producing (this is from trying and failing to sample grease by sucking it into a syringe).