Free Drawer Glides, Last Entry
David Frame
Gentleman,
Here is a secret I've kept to myself for 22 years where any accomplished shop personnel can rebuild 500lb drawer glides. Many need no restoration. They were swapped out because of weight of the computer equipment they roll out. The glides were replaced if there was a stopping or sticking point in them where it shouldn’t be. There may be a Schlumberger Wire Line Office with electronic down hole tools near you. There or at the facility this company rebuilds its own equipment in that area, you should find large aluminum extrusions measuring approximately 24 3/4" in length x 3 1/2" in height x 7/16" in thickness. Extending close to 51", they are three section and have no trademark on them. I'm fairly sure they’re custom made for Schlumberger's computer modules. They will need cleaning, possibly milling or routing, and can be cut to the length of about 22". Maybe smaller. Pay particular attention to the rear of them before cutting. There is a pin on the top and bottom of the largest section to keep 8" of 1/8" ball bearings from falling out. I hope you make a find and put them to good use. They may not be pretty, but they're excellent for shop use.
Now on to other business. I know I've have offended many of you with my ego. It was never my intention to hurt or put anyone of you down. I have character defects like everyone else. But sometimes, my shortcomings are glaring. To the point, please forgive me and my insanity. I'm going into the hospital after 40+ years of smoking. Maybe I'll see y'all on the other side. Good Luck and Goodbye. May the wood gods be good to you.
Thank you all for your help over the years and God bless,
David L. Frame Jr.



