Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Some help needed

Posts

Some help needed

#1

Some help needed

Marty

OK all of you antique junkies. I have a table, made in 1943,so it says on the bottom. The finish is great, except for the top. We acquired it and the top of the table's finish has been sanded off. Left behind are a few water stains from a wet glass, yes, on the raw wood. I need to know how do I remove them? Not sure if the top of the table is a Veneer or Solid Mahogany. From looking at the side it appears to be solid, but even back in 1943 Veneer's were used. Need a little help, Thanks, Marty

Re: Some help needed

#2

Pictures willl help

Gary Smyth

Are the rings dark or light? Surface or deep? What other stains? Dings? Look hard at the edges of the table with a magnifying glass. Any glue line should show. I'm guessing that in 1943 wood was scarce, especially if it was non-domestic wood. If veneer about 1/16 thick often hidden by the edge finish.

What is the value -- heirloom, daily use? Possible help could be with diluted bleach, vinegar, salt, baking soda, wax, oil and kerosene, pumice, artist color painted grain and/or pearl drops toothpaste. Bare wood on your table may be an advantage because you can refinish the whole top with many finishes once the rings are corrected -- you won't have to match so closely the affected area with adjacent wood. If push comes to shove, a reskin of the top might be possible if the table has enough value.

Re: Some help needed

#3

Re: Some help needed

Lee Schierer - McKean, PA

I've had success removing water stains from raw wood by wetting the entire surface with distilled water and wiping down the water mark areas with a clean cloth and letting the surface dry. This may not work if the stains are from coffee, tea or other beverage.

Lee

Re: Some help needed

#4

Re: Some help needed

Marty

Thank y'all for the suggestions. I'll try the distilled water first. Pictures???? I am as old as the table in question. Out of the question, I am lucky to operate a "smart phone", with out the help of a 9th grader

Re: Some help needed

#5

If water doesn't do the job and... *LINK*

Gary Smyth

you obviously have access to the internet, go to "You Tube" and search for " rings on table top" a number of videos will be available for your dilemma. If you find a video that is similar to your situation, test that. Keep in mind that not all videos work as shown. Test small before working big area.


https://www.youtube.com/results?search_query=rings+on+table+tops

Re: Some help needed

#6

Re: If water doesn't do the job and...

Marty

Thank y'all for ALL of the suggestions. I did try the Distilled water, did it three times, and the rings have gone away....Now to stain the top to match the rest of the table. Thank y'all again,